First
Generation Engine crossmember
1969-1972 full size Chevy/GMC
This is a complete
kit that allows you to get rid of the old school engine mounts
and upgrade to a better design all the way around. Oil pan access
is a snap, pull the crossmember from the frame mount boxes and
drop the pan with ease. All necessary hardware is included. Construction
is primarily 1/4" thick steel.
ATTENTION! we have made some changes to the first gen engine crossmember. For more information please call.
00440 - BUY IT NOW - $205.00 
Competition
Poly Motor Mounts
Designed to be a bolt in for 1973-87('91) Full size Chevys. These
are an upgrade in strength as well. Factory mounts use rubber
and a 1/2" bolt while these are poly urethane and a 9/16"
bolt. 1/4" thick steel throughout. Comes complete with everything
you see in the photo and all the hardware is Grade 8.
Comp. Poly motor mounts - Part no. 00400 - $85.00
Engine
Seal Kit
Intended for long term storage. Bags are fine for short term but
will never hold up for very long. Everything in the kit is 10ga.
steel except for the lift plate which is 1/4". Not pictured
is a steel cap for the distributor hole.
SBC,
Exhaust port seals, water pump and water neck seal, fuel pump
block off and lift plate. Fuel pump block off is heavy enough
to use as a permanent block off when switching to an electric
fuel pump.
Other kits coming soon!
Part no. 00210k - SBC - $25.00
Engine
Balance Plate
If your building a 383 or a 406 that's externally balanced when
using the small 350 flexplate, you'll need one of these. Made
from 13ga. cold rolled steel. Clearly marked for flywheel side.
00220k - balance plate - $9.00
